After very small files?

[BattleshipBob]

Afternoon all

I am looking for very small/fine files, escapement ones? A set is expensive but found a 2.3mm round file on evibay, has anybody else bought these??

I have removed the anchor chains from Graf Spee and have drilled out the holes in the deck for the chains, however they are slightly oval. I have the generic set of diamond micro files but they are too big!

 

[adt70hk]

Sorry Bob can't help. Hope you get it sorted.

ATB.

Andrew

 

[minitnkr]

I've used drill bits in a pin vise.

 

[BattleshipBob]

I've used drill bits in a pin vise.

New to me lol, thanks for that!!

 

[Tim Marlow]

Something like this might help Bob

Vallorbe Midget Needle Files

Needle files are also known as Swiss Pattern or Jeweller's files. These small files are very accurately made and designed for precision work or delicate small work. Overall length is approximately 155mm. Also available is the 300189 universal needle...

www.axminstertools.com

However, I would check with them to make sure it’s fine enough.

Edit, according to the questions section it goes down to 1.2 mm

 

[Tim Marlow]

Another option is this…

Modelcraft 1.2-3.0 mm Cutting Broach Set, Silver : Amazon.co.uk: Home & Kitchen

Modelcraft 1.2-3.0 mm Cutting Broach Set, Silver: Modelcraft 1.2-3.0 mm Cutting Broach Set, Silver: Amazon.co.uk: Home & Kitchen

www.amazon.co.uk

Ive used them for years. Saves a fortune on miniature drill breakage….

 

[BattleshipBob]

Many thanks Tim, have messag them

 

[BattleshipBob]

Found another modelcraft set 0.6 to 2mm, that will do the jobs

 

[Tim Marlow]

Found another modelcraft set 0.6 to 2mm, that will do the jobs

There are lots about Bob. Mine are designed to be used in pin vices, but they pre date the modelcraft ones by many years
The advantage of broaches over needle files when enlarging holes in sheet stock is that a five sided broach won’t drift off centre. If you do go down the file route you will find that simply rotating them anti-clockwise will do what you want. If you rotate them clockwise they wind into the hole like a drill and bind. Personally, I would aim to get both because in my opinion they are both very useful tools

 

[BattleshipBob]

Thanks Tim, do not use many files but will get the broaches to do the anchor hole