Mark1
SMF Supporter
Hi everyone, Im having problems with chipping fluid and wondered if any could give me some advice as to where I'm going wrong, I bought an ak chipping set, used the ak base colour supplied,left for 3 days to dry then applied chipping fluid and top coat, when I started to chip everything came off back to the primer, I tried again but this time i sealed the base with Matt varnish which was left to dry 24hrs, applied chipping fluid and top coat and had exactly the same issue again,back down to primer! Third attempt I sealed with gloss varnish but top coat seemed a bit 'rubbery' when chipping ,top coat was left a couple of hours to dry! Am using mission models for top coat and they suggest using thinner rather than water for chipping process and that did seem to perform better than water. If anyone's had these issues and solved them I would great full for any advice, I know it's trial and error and I'm glad I only done the loading ramps and not the whole trailer lol.