sorry for late reply busy day
hi Steve,thank you, it is only a new AB that come with the compressor i will , look again and do another clean and take on board what you have said
,when i did change the needle the lever guide did drop out ,oops so i put it back in thinking it is the right way around, as it dose have a curve on each end
but dont think it would real matter beening around the wrong way ? as the needle moves find when pulling the trigger
i did find that with the needle cap that was on it was so hard to undo it broke the o-ring, the one thing im a little confused about is the PSI ?
,should i try at 20 1st and see how i go ? with the right thinners and do as said
:oops:
or do I try it set to 25 ? as Steve has said
or do i try your way and have it set higher ?
hi Tony thank you as well , yes that screw i messed with when i was getting the spattering , which maybe i should not off touch oops, again,
and maybe im right in saying that using the wrong thinners gave me most off the problems ? as i did find that the paint was building up on the tip and was drying
as i read that the air thinners has a bit off a slower drying time maybe that will stop the paint drying on the needle cover ?
i do have a busy day tomorrow and the air thinners should get to me by Friday so i will have a play about then and thank you all for the help , we will get it sorted :rolleyes:
its not scarey at all dont know why i waited so long to try it , just nuffed things up :rolleyes: